OBP40 integration code and improvements

lib/obp60task/platformio.ini

@@ -59,3 +59,45 @@ upload_port = /dev/ttyACM0          #OBP60 original
 upload_protocol = esptool           #firmware upload via USB OTG seriell, by first upload need to set the ESP32-S3 in the upload mode with shortcut GND to Pin27 
 upload_speed = 230400
 monitor_speed = 115200
+
+[env:obp40]
+platform = espressif32@6.8.1
+board_build.variants_dir = variants
+board = obp60_s3_light_n8r8   #ESP32-S3 N8R8, 8MB flash, 8MB PSRAM, OBP60 clone
+board_build.partitions = default_8MB.csv #ESP32-S3 N8, 8MB flash
+custom_config = config_obp40.json
+framework = arduino
+lib_deps =
+    ${basedeps.lib_deps}
+    Wire
+    SPI
+    SD
+    esphome/AsyncTCP-esphome@2.0.1
+    robtillaart/PCF8574@0.3.9
+    adafruit/Adafruit Unified Sensor @ 1.1.13
+    blemasle/MCP23017@2.0.0
+    adafruit/Adafruit BusIO@1.5.0
+    adafruit/Adafruit GFX Library@1.11.9
+    #zinggjm/GxEPD2@1.5.8
+    #https://github.com/ZinggJM/GxEPD2
+    https://github.com/thooge/GxEPD2
+    sstaub/Ticker@4.4.0
+    adafruit/Adafruit BMP280 Library@2.6.2
+    adafruit/Adafruit BME280 Library@2.2.2
+    adafruit/Adafruit BMP085 Library@1.2.1
+    enjoyneering/HTU21D@1.2.1
+    robtillaart/INA226@0.2.0
+    paulstoffregen/OneWire@2.3.8
+    milesburton/DallasTemperature@3.11.0
+    signetica/SunRise@2.0.2
+    adafruit/Adafruit FRAM I2C@^2.0.3
+build_flags=
+    -D DISABLE_DIAGNOSTIC_OUTPUT    #Disable diagnostic output for GxEPD2 lib
+    -D BOARD_OBP60S3                #Board OBP60 V2.1 with ESP32S3
+    -D HARDWARE_LIGHT               #OBP60 hardware clone (OBP40)
+    -D DISPLAY_GDEY042T81           #new E-Ink display from Waveshare, R10 2.2 ohm
+    ${env.build_flags}
+upload_port = /dev/ttyUSB0          #OBP60 clone
+upload_protocol = esptool           #firmware upload via USB OTG seriell, by first upload need to set the ESP32-S3 in the upload mode with shortcut GND to Pin27
+upload_speed = 230400
+monitor_speed = 115200